Free Delivery available

Ancon MDC Masonry Support

Sort By

Bespoke Bracket Angle Support (MDC)

Ancon MDC Bracket Angle Support Systems can carry over 8 metres of brickwork and accommodate any width of cavity from 50mm in its standard form. The brackets are welded to the angle and the material content of both components is optimised to ensure the most economic solution is designed.

There are several variations of the standard MDC System that allow the support angle to be positioned anywhere from the top of the bracket to a position below the bottom of the bracket.


Standard configuration


MDC/R has a reversed angle


MDC/I is an inverted system with the support angle at the top of the bracket


MDC/P has the bracket projecting below the structure 


MDC/P/NB has a notched bracket

Modular Brick-Faced Units

Ancon MDC systems can be designed and manufactured to support modular factory made brick-faced units, where brick slips are adhered to either steelwork or precast concrete. The units are simply bolted to the underside of the prefixed support angle. 

MDC Nexus®

Lightweight, prefabricated Nexus® brick-faced units by Ibstock Kevington bolted to MDC angle

MDC with Precast Masonry Unit

Brick-faced precast concrete unit bolted to MDC angle

For in-situ construction, the MDC system can be designed with stirrups, stitching rods and soffit angles.

Details for Specification and Ordering

Ancon MDC Systems are tailored to suit each contract, and are based on the cavity size at the support and the unfactored masonry load to be carried. Ancon will design an economical configuration of channel, bracket and angle.

Specification is as follows:

MDC/type/cavity/unfactored masonry load

e.g. MDC / R / 75 / 5.6
Ancon will design a system with a reversed angle to suit a 75mm cavity and carry 5.6kN/metre run of masonry (unfactored).

Some applications demand that the support leg is below the soffit of the structure. Where this is no more than 150mm, this can be specified as a suffix to the standard reference by . . . . . . P projection.

MDC/cavity/unfactored masonry load/projection

e.g. MDC / 125 / 7.2 / P 75
Ancon will design a standard system to suit a 125mm cavity, carry 7.2kN/m (unfactored), with a bracket projection of 75mm.

Building Information Modelling

Ancon now offers BIM Objects to cover a wide range of our market-leading products, to freely download our objects please visit


Adjustment is provided in every direction to allow for tolerance in the structural frame. The serrated and slotted face of the bracket allows for vertical adjustment. Cast-in channel will provide virtually unlimited horizontal adjustment; slotted holes in a steel edge member will offer more limited adjustment. Shims can be included between the bracket and the frame up to a maximum thickness of the outside diameter of the fixing bolt, or 16mm, whichever is less. When used, the 3mm thickness of an Ancon Fire-Tested Thermal Break should be taken into account when calculating the maximum shimming allowance for a system.

Extension Plates

As an alternative to shims, Ancon Extension Plates can sometimes be used to increase the bearing for the brickwork.

Ancon Extension Plates are designed to be used with Ancon Support Systems. The particular application should be agreed with Ancon technical staff to ensure that both the support system and extension plates are suitable. Contact Ancon's Technical Services Team for more information.

These extension plates are pushed onto the leg of the angle with the flat surface on top. They are adjusted until the required amount of extension is achieved, this will be from 5mm to 17mm.